Microwave Propulsion Realised: In a relatively new experiment ,yours lovingly has achieved a great deal of experience and an important objective which is nothing but a re-inventing the wheel of microwave propulsion. since my design needs to be much more validated and many other incorporations,I am not intending to push the design onto public sites,though I would love to share the concept and objective harvesting. the whole thing costed me no more than 210 CAD.And for picky people it will come up with a cost of 100 bucks. Bought 3 ovens in a "Going out of business sale" paying $40 each for a 1200KW one.(you can get the magnetron only for a far less price than what I paid for) Ran to the electronics store and bought the components(diodes,transistors,resistors,toroids,.....) for 60 bucks.And then ran to home hardware to buy some clamps,plates,.....for $30(altogether just 210 bucks) Unscrewed each and every oven to take out my needed parts(magnetrons,wave guides,motors,) Now I had 3 1200KW magnetrons handy with few samples of wave guides to kick start my experiment. After recalling that old microwave propagation theory which I studied many many years back,connected all components together to the best of my knowledge using some self designed amplifiers . As per my surprise,I observed that the paper board with 0.5 mm thickness was thrusted with significant force.( for sure the thrust created is significant from what I observed) this experiment is done only after reviewing few research papers done by folks at some local universities,but I added some sub-critical components to add more thrust. I would have produced a spread sheet with the readings ,if i had any related test bed. But from what I observed: A whole setup with a gross weight of few grams over 1Kg forced a 0.5mm thick paper board to go out of its way.Apparently such a device cant be used for propelling aircrafts given its low thrust, but will be significantly helpful in outer space.